360 Spec/IMCA Engine

350 block (010 casting) .060 bore.
Front and rear main are strapped, Callies billet main caps on middle three.
Crower 4340 superlight crank (34 lbs).
Scat Pro-lite 4340 I-beam rods with Mahle flat top pistons and Mahle rings.
Clevite "H" bearings.
Comp cams custom ground came with comp Endure-X roller lifters.
Howards 4130 .080 wall pushrods.
PEP guide plates and PEP stud girdle.
Cloyes Hex-A-just timing set.
Brodix spec. aluminum heads and Brodix spec. aluminum intake.
Manley pro-fro stainless valves.
Howards pro-endurance valve springs.
Titanium retainers.
Comp cams locks.
ARP main studs, head bolts and rocker studs.
Victor gaskets.
Comp cams 1.7 Hi-tech stainless roller rockers.
Aluminum valve covers.
Pro-pan dry sump pan.
Engine is fresh and ready to run.
It would cost 13-15K to duplicate this engine. Will also include a complete dry sump oiling system for the right offer.
All offers considered.

This item is USED

Trades NOT ACCEPTED

Item Location: SPRINGFIELD, MO

This ad expires in 45 days.