NEED TO SELL 68 CUTLASS

NEED TO SELL ASAP!!!
1968 BIGBLOCK CUTLASS 442(CLONE)
ENGINE=
455 BORED .040, block and heads decked, mains aligned bored,polished and balanced nodular crank,stock rods(polished), speed pro forged pistons, comlete mondello oiling system,ported and polished heads, ss valves,roller rockers,recurved proform dist., edelbrock single plane,holley 750, headers,3inch flowmasters.
Muncie m21
12 bolt olds rear, posi, 4:10 gears
hurst shifter with original 442 stick
p/s
p/b (disc/drum)
red w/black vinyl top and black bucket seat interior w/original center console
runs great, sounds great, never goes over 175 degrees and never goes below 65 psi oil pressure.
car does need some body work
rf fender has some filler(I am sure other panels on car also do) rear qrts have some bubbling and chrome should be replated(good cores)
interior needs the most attention, seats are worn out, carpet is worn out, head liner is starting to split at seams, but the dash pad si very nice
GOOD LOOKING CAR AT 20FT.
WOULD MAKE A GREAT FATHER/SON PROJECT(that was my plan) or restore a little bit at a time while you drive.
need to sell ASAP! NO TRADES! CASH TALKS!

This item is USED

Trades NOT ACCEPTED

Item Location: BELLE VERNON, PA Get Directions

Instructions for buyer:  CALL BEFORE 9:00PM EST OR EMAIL
LEWIS15012@COMCAST.NET

This ad expired 50 days ago.